Roof Calculator totals roof estimates

Using Roof Calcuator and Roof Bidding Software Job

Roofing Job Cost Grid

The Job Cost Grid displays and calculates your bid numbers

The divisor column divides all your totals, what you enter in this column is very important
The Job cost Grid is the main focal point of the RoofCalWriter program.
It collects all the numbers you have entered and divides them into the usable units you have specified. It totals your squares and calculates your total price based on the price per square you enter.
The yellow shaded cells in the units column is where you will always enter your price per square.
The top row is a total of your roof area measurements with pitch and waste added.
The second row is a total of your Hip feet + Ridge Feet and optionally your Rake ft if this box is checked:

The third row is a total of your eave measurements and optionally your Rake ft if this box is checked:

The fourth row is a total of your roof area measurements with pitch added (If needed)
The fifth row is a total of your valleys with pitch added (If needed
The sixth row is a total of your roof area measurements with pitch added (If needed) (useful for OSB or ?
The seventh row is a total ft. of your eaves.
The eighth row is a total ft. of your rakes with pitch added (If needed)
All the numbers in the unit column are calculated by total ft. / the Divisor you enter
To not use any of these rows leave the Divisor blank.

To view your individual numbers click this button:
Check these numbers against your estimate sheet actual roof measurements.

We are adding for 5/12 pitch 4185 is the total of your actual roof measurements. The Sub-Total is 4185 x 1.08 = 4519.80, = pitch has been added. Notice we have added for valley, hip and rake waste. (Set in options)

See the details of totals with pitch & waste added by clicking this button: